Thank You For Shopping at Gift Gallery 1000

We appreciate your business and just want to say a big Thank You for choosing Gift Gallery 1000. We know there are other options out there and we want you to know that your purchase has not gone un-noticed.


Your order is currently being processed, and we will let you know when it has been shipped, and when approximately you can expect it to arrive. Most orders that are in stock will be shipped within 2 – 7 days. If your selection is not in stock you can expect up to 2 – 3 weeks till we ship. In either case you can rest assured that we will get to your order as soon as it is possible.


If your order has to be shipped outside of Canada you can expect a few extra days because of customs, border security etc.


Beeswax candles are very special and have to be treated accordingly. Please take some time to read through the burning instruction below to get the most out of your candles.


We would love to hear from you. Please send us your testimonials and we might just post them on our website, you can send us a message on our "Contact Us" page.

"We love your beeswax candles They give out such wonderful light and seem to last and last and last... We always have them lit when we have friends and family over, and everyone comments on how wonderful they look and the ambiance they create. We will never use anything but your candles. You are the best"   R & A Ray

Burning Instructions

To get the most out of your beeswax candles, please follow the burning instructions carefylly, become a candle master.


As a general rule, light or relight your candle with the wick trimmed to ¼ inch. Always put your candle on a base for safety. Our unique plant fibre wick may take a few seconds to catch. Hold the candle on an angle for best results. Following your first burning, the wick may sputter as you light it. This is normal, but please be careful. Before lighting your candle, please remove the decorative wrap. For best burning results, try to maintain the wick at about a ¼ inch height.


While enjoying your candlelight, a pool of liquid wax will move toward the edge of the candle, then gently push or hug the walls inward to create as smaller pool, shorter flame and extended burn time. This will take a bit of practice, some patience and lots of care. Remember, the wax is very hot.


The flame of your candle will "tell" you when it requires maintenance: It will dance or flicker, and may smoke slightly ( this is the wick burning). Should this occur, do one of two things: hug the sides first, if this is not sufficient, then extinguish the candle then trim the wick. It is a good idea to have some paper towel ready to wipe the wax off the scissors. If hugging the walls is insufficient, then trimming the wick is a must.


Never allow the pool of wax to go beyond ¼ inch from the edge of the candle: it could leak thru the side, thereby shortening the life of the candle. If so, immediately extinguish the flame and allow the candle to harden before relighting.


The key to maximizing the burn time of your candle is to maintain a level top all around. To achieve this, allow the pool to ¼ inch from the edge every 2nd burning.


By following these instructions, you will use the entire candle down to a ½ inch puck. It can also be used, just let us know and we will fill you in on the details.


Because of our unique plant fibre wick, you should never blow out your candle. Instead use a snuffer or, better yet, "dunk" or push over the wick into the pool of wax. For this use a toothpick, paper clip, pencil, or what we have found works well is a chop–stick and some paper towel to wipe the wax off. You are a candle master - Enjoy!



▲ Top of page